Cheapo repair
-
- Posts: 1911
- Joined: Sat Sep 04, 2021 1:47 pm
- Location: sw 29
Cheapo repair
I haven't used my 22 yo pug 806 for yonks & the other day I found the headlining had come adrift & was hanging down like a sad old pair of curtains..
A pucker specialist repair would have cost more than the car was worth so a DIY job was required.
6 hours for me & a pal with a hair dryer had it pretty much back in place & if comes unstuck again the pop on buttons will ensure it doesn't go far.
Result for about 16 euros & bit of graft.
A pucker specialist repair would have cost more than the car was worth so a DIY job was required.
6 hours for me & a pal with a hair dryer had it pretty much back in place & if comes unstuck again the pop on buttons will ensure it doesn't go far.
Result for about 16 euros & bit of graft.
You do not have the required permissions to view the files attached to this post.
- Char
- Site Admin
- Posts: 2848
- Joined: Mon Jul 19, 2021 1:24 pm
- Location: Creuse
-
- Posts: 1911
- Joined: Sat Sep 04, 2021 1:47 pm
- Location: sw 29
Cheapo repair
Male part of the set which attaches to the headliner board with screws.
Bit of a faff getting them in nice lines when the roof has so many compound curves but the result was quite pleasing.
- Char
- Site Admin
- Posts: 2848
- Joined: Mon Jul 19, 2021 1:24 pm
- Location: Creuse
-
- Posts: 764
- Joined: Mon Jul 19, 2021 10:09 am
Cheapo repair
Thanks for that. The roof lining in my Golf is held up by two wooden disposable forks in the middle of the car, they’re wedged into the rear passenger light. I must get around to finding a better solution. The problem is that the temporary ‘fix’ is good enough to make it out of sight and out of mind.
-
- Posts: 565
- Joined: Sun Jan 02, 2022 11:51 am
- Location: 23 la Creuse
Cheapo repair
Bit more push and it would look like a chesterfield sofa. Great fix, I would never have thought of that.
-
- Posts: 1911
- Joined: Sat Sep 04, 2021 1:47 pm
- Location: sw 29
Cheapo repair
If anyone has a sagging liner & wants a quick & simple fix to hold it up, twist pins could be the answer.
Easy to use & relatively unobtrusive.
https://www.amazon.fr/dp/B08YR4VS4D/ref ... item_image
Easy to use & relatively unobtrusive.
https://www.amazon.fr/dp/B08YR4VS4D/ref ... item_image
- Hotrodder
- Posts: 2377
- Joined: Mon Jul 12, 2021 8:31 pm
- Location: Brittany 22
Cheapo repair
Respect
It must have been an absolute pig to get access without undoing all around the edges. I have done a few overhead linings on boats and they were all very tricky, even using a new oversized lining.
Edit: Having looked at the Amazon link it appears that you don't have to get behind the headlining at all. It appears that you just use the drawing pins in the kit to establish where to place the buttons. Hopefully there is a hard lining in there somewhere to take the self-tappers that hold the button snaps. In the cars I have experience with you would have to drive the screws into the roof which would be less than ideal, especially when it rains.
It must have been an absolute pig to get access without undoing all around the edges. I have done a few overhead linings on boats and they were all very tricky, even using a new oversized lining.
Edit: Having looked at the Amazon link it appears that you don't have to get behind the headlining at all. It appears that you just use the drawing pins in the kit to establish where to place the buttons. Hopefully there is a hard lining in there somewhere to take the self-tappers that hold the button snaps. In the cars I have experience with you would have to drive the screws into the roof which would be less than ideal, especially when it rains.
Last edited by Hotrodder on Thu Sep 15, 2022 10:02 am, edited 1 time in total.
Humanity landed on the moon over fifty years ago but it seems too much to ask for a reliable telephone/internet service in rural France.
-
- Posts: 1911
- Joined: Sat Sep 04, 2021 1:47 pm
- Location: sw 29
Cheapo repair
This morning the lining had pulled away in a few places on compound concave curves but only just noticeable as the pop studs held it in place.
It seemed like maybe the hair dryer had not reconstituted the glue sufficiently so I tried steam from my wife's steam cleaner on them.
Seems like the steam has worked as all is now good & the cloth certainly seemed more inclined to take the odd shapes.
So far so good!
It seemed like maybe the hair dryer had not reconstituted the glue sufficiently so I tried steam from my wife's steam cleaner on them.
Seems like the steam has worked as all is now good & the cloth certainly seemed more inclined to take the odd shapes.
So far so good!
- Bayleaf
- Posts: 2721
- Joined: Thu Sep 02, 2021 7:22 am
- Location: NE Dordogne
Cheapo repair
Following with interest! We also have an old car that needs the same treatment ..... all methods of glueing etc. have been unsuccessful so far.